[geegeemoe]

Hello,

We have been running Untangle 6.x at the office for 3-ish months. The system did the automatic updates with no issues untill...

We have a static IP setup with 4 outside IP addresses. I had mapped 2 additional addresses to port forward HTTPS to internal servers. All was working well.

I turned down our network so we could run some new wiring and clean up the physical network. We moved the internet connections and the server rack to the other end of the room. Reconnected it all and then fired it all back up.

After that cold start everything worked as before EXCEPT port forwarding. I had even done a backup of the config before shutting the server down. I reloaded the config, and still no outside access to our 2 web servers.

I had previously changed the outside management access to another port (2443) so that it would not conflict with these forwards. I also checked to make sure it had not reverted back to the default.

I tried many of the suggestions in the forum, including deleting all port forwarding rules and starting from scratch. Nothing has worked so far to restore the forwarding. Everything else still works great and all users have internet access, and my OpenVPN connections still work. I can access the sites from the internal network, so I know the web servers are running.

I have attached a screen shot of the port forwarding rule that was working before.

I am hoping not to have to do a full re-install (and reload the config). All I did was shut it down, walk it to the other side of the room and turn it back on.

Any suggestions are greatly suggested.

Thanks,
G