Untangle Forums - View Single Post - Proper Port forward / Firewall Filter: RDP

ChTechCoord · 06-30-2009, 06:51 PM

I have been working on this, and researching the thread since installing UT about 3 weeks ago. I have not been able to allow RDP (3389) to pass through to the server.

The servers internal IP address is 1.3.
The UT internal IP: 1.1
Installed NAT for my public IP address.

Setup rule to allow 3389 to pass from external port to 1.3

I can remote the UT fine,.. but all attempts to RDP to the server fails. I added PROTOCOL to the Rack to filter trace things, but I don't see any port 3389 traffic - not being logged or blocked according to the event log.

I've followed the Troubleshooting guide, compared other settings, and still fail.

Looking for some suggestions. Thanks.

06-30-2009, 06:51 PM	#1 (permalink)
ChTechCoord Untanglit Join Date: Jun 2009 Posts: 14	Proper Port forward / Firewall Filter: RDP I have been working on this, and researching the thread since installing UT about 3 weeks ago. I have not been able to allow RDP (3389) to pass through to the server. The servers internal IP address is 1.3. The UT internal IP: 1.1 Installed NAT for my public IP address. Setup rule to allow 3389 to pass from external port to 1.3 I can remote the UT fine,.. but all attempts to RDP to the server fails. I added PROTOCOL to the Rack to filter trace things, but I don't see any port 3389 traffic - not being logged or blocked according to the event log. I've followed the Troubleshooting guide, compared other settings, and still fail. Looking for some suggestions. Thanks.