Adding second ISP to Untangle

[rmaccara]

Our Internet all along has been a single 7Meg ADSL connection (shared by 50 users!) and we just got a cable 40 down/10 up connection today.
The new connection is on the DMZ as showed in the attachment along with its configuration page.
My question now is what do I have to do for Untangle to take advantage of the new high speed connection?

[jcoffin]

You need WAN balance to use both from the LAN.

[hlarsen]

My question now is what do I have to do for Untangle to take advantage of the new high speed connection?

Install WAN Failover and WAN Balancer, configure tests in Failover and weights in Balancer, set your WAN speeds at Config > Networking > Advanced > QoS if you want to use QoS, and you're done.

[rmaccara]

I've already set Wan Balance to 25% and 75% with the larger going to the broadband connection.
I also added the total bandwidth for each eth on the Networking > Advanced > QoS page.
No change in Internet speed.
I'll see if I can figure out the WAN Failover tests.
Thanks for all your help!

[rmaccara]

In WAN Failover, the error message for both eth is Unable to complete test. I had it set to the default of ping to Google's DNS.

[rmaccara]

Also note there there are no sessions on my DMZ connection.

[hlarsen]

are the failover test passing for that WAN?
did you set up any Source Routes in Balancer that may be pushing all traffic out the External?

[jcoffin]

Can you ping the DMZ gateway IP from the Untangle.

[rmaccara]

Can you ping the DMZ gateway IP from the Untangle.

Yes - I can ping it from a terminal session within Untangle.
I've got nothing set up for source routing - should I?
Here are my active routes - hopefully this will shed some light.

[jcoffin]

I would call support so they can troubleshoot the issue.