Results 1 to 3 of 3
  1. #1
    Newbie
    Join Date
    Nov 2011
    Posts
    8

    Default VMWare Installation - Gateway for Clients

    I chose bridge mode(transparent), but on my clients unless i give them the ip address of the untangle box as their gateway they cannot ping the router???

    VMWare virtual machine. I have checked to make sure i have 2 virtual switches seperating the physical NIC's, and they are correct on the external and internal.

    This sounds like its not in bridge mode but in router mode instead, how to i make sure of this?

  2. #2
    Untangle Ninja sky-knight's Avatar
    Join Date
    Apr 2008
    Location
    Phoenix, AZ
    Posts
    26,497

    Default

    You don't assign clients to use a bridge as thier gateway.

    Bridge mode vs Router mode is determined by Internal's configuration. If it's static, you're a router, if it's bridge, it's a bridge.
    Rob Sandling, BS:SWE, MCP
    NexgenAppliances.com
    Phone: 866-794-8879 x201
    Email: support@nexgenappliances.com

  3. #3
    Newbie
    Join Date
    Nov 2011
    Posts
    8

    Default

    So my problem was because I didn't properly have "promiscuous" mode accepted on the vmware NIC's. All was fine after i turned the adapters to promiscuous accepted.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

SEO by vBSEO 3.6.0 PL2