Transparent Bridge

[Loudog2]

Hi,
Jumping in on this thread if y'all dont mind. I have the following - > FIOS StaticIP ( no VZ router ) --> into WAN of USG Pro 4 ---> USG Switch24-POE ----> USG48--> out to clients ( with a USG CloudKey hanging off one of the POE ports )
Can I put untangle in-between the USG Pro and the first USG Switch24?
Will I still have full management on the USG equipment? Defined VLANS still work etc...?
Thanks

I have the same set up with untangle in bridge mode. USG pro4—>untangle—>USG 16. Everything works fine.

[tizigman]

Support emailed me this link to correct the issue with version 14.
https://wiki.untangle.com/index.php/...y_initializing

[Loudog2]

Support emailed me this link to correct the issue with version 14.
https://wiki.untangle.com/index.php/...y_initializing

See I knew we were not doing it wrong. The wizard was.

[egbeta]

Hey all,

Does anyone know if this issue is fixed in version 14.0.1? I want to eliminate this as a potential cause of an issue I'm having. Thanks, Chuck

Support emailed me this link to correct the issue with version 14.
wiki.untangle.com/index.php/Patch_-_Bridge_VLANs_not_properly_initializing

[jcoffin]

All patches are rolled into 14.0.1.