View Profile: jcoffin - Untangle Forums

Today, 05:42 PM

jcoffin replied to a thread Host exceeded error in NG Firewall General

From above

4 replies | 91 view(s)

Today, 08:03 AM

jcoffin replied to a thread Allow traffic initiated by trusted LAN to untrusted VLAN, but not the reverse in Networking

It's easy to do in Config -> Network -> Filter Rules. Conditions: Source Interface = <untrusted network> Action : Block. This will...

3 replies | 61 view(s)

Today, 07:59 AM

jcoffin replied to a thread Host exceeded error in NG Firewall General

Do you have Apple products on the network? They use rotating MAC addresses which will cause the issue above. You can select which WiFi networks...

4 replies | 91 view(s)

Yesterday, 08:00 AM

jcoffin replied to a thread Changing WAN address and OpenVPN in SD-WAN Router General

For locations without a staic IP, I use Dynamic DNS Service Configuration in Config -> Network -> Hostname so the hostname in the OpenVPN config is...

10 replies | 145 view(s)

Yesterday, 07:38 AM

jcoffin replied to a thread Forward internal traffic to an internal IP in Networking

Yes, Port forward works in either direction. Port forward rule: - Interface is non WAN - UDP - Port 53 Redirect to <IP of Pihole server> ...

2 replies | 67 view(s)

10-14-2021, 07:58 AM

jcoffin replied to a thread Troubleshooting guidance in Networking

I've seen case where the access point has a feature to check if it is online. Some apps (Threat Prevention and IPS) on NGFW could case issues with...

2 replies | 96 view(s)

10-13-2021, 12:26 PM

jcoffin replied to a thread How to set report timestamps to 24hr clock not am/pm in NG Firewall General

- Go to Config -> System -> Regional - In Regional formats, select override, then modify the time and date as desired. ...

2 replies | 99 view(s)

10-12-2021, 11:37 AM

jcoffin replied to a thread It's a WAF! in Web Application Firewall (WAF) General

Nope, just nginx is the right tool for WAF.

11 replies | 584 view(s)

10-12-2021, 09:34 AM

jcoffin replied to a thread It's a WAF! in Web Application Firewall (WAF) General

Yes, WAF is specifically a reverse proxy.

11 replies | 584 view(s)

10-11-2021, 09:43 AM

jcoffin replied to a thread Ipv6 in Networking

It's planned but not set for a targeted release yet.

6 replies | 247 view(s)

10-11-2021, 09:41 AM

jcoffin replied to a thread Can't remove wireguard in WireGuard VPN

Try refreshing the browser. It might be a stale state.

1 replies | 132 view(s)

10-11-2021, 06:59 AM

jcoffin replied to a thread Ipv6 in Networking

IPv6 has limited support with router or transparent mode. PPPoE requires DHCPv6 for IPv6 so in this case NGFW is probably not the solution.

6 replies | 247 view(s)

10-10-2021, 06:02 PM

jcoffin replied to a thread Ipv6 in Networking

We currently do not support DHCPv6 on NGFW. You could assigned an IPv6 to the device and NGFW will do IPv6 passthrough. ...

6 replies | 247 view(s)

10-07-2021, 07:50 AM

jcoffin replied to a thread NIC card connected at 100Mbit in Hardware

It's fixed now.

15 replies | 662 view(s)

10-06-2021, 07:26 PM

jcoffin replied to a thread NIC card connected at 100Mbit in Hardware

Thanks for reporting the issue.

15 replies | 662 view(s)

10-03-2021, 08:05 PM

jcoffin replied to a thread NIC card connected at 100Mbit in Hardware

It could be an issue with the auto-negotiation on the switch on the LAN.

15 replies | 662 view(s)

09-29-2021, 12:16 PM

jcoffin replied to a thread NG Firewall on WRT1900ACS Installation Instructions in Installation

DM me your email and I will send it.

5 replies | 310 view(s)

09-29-2021, 12:04 PM

jcoffin replied to a thread NG Firewall on WRT1900ACS Installation Instructions in Installation

We have not supported NGFW on Linksys for some time now. ~ version 14.1. I miss running it on Linksys.

5 replies | 310 view(s)

09-27-2021, 12:31 PM

jcoffin replied to a thread Message: Cannot read properties of null (reading 'list') in Reports

The JSON errors would help.

2 replies | 317 view(s)

09-27-2021, 06:37 AM

jcoffin replied to a thread Are there external switches or APs that Untangle can manage? in Hardware

Untangle cannot manage third party devices.

3 replies | 313 view(s)

09-26-2021, 04:07 PM

jcoffin replied to a thread filter_blocked? in Firewall

I imagine the filter rule has blocked unchecked. Most like this is due to the order of the rules. The pass rule must be higher in the list than...

3 replies | 404 view(s)

09-24-2021, 11:08 AM

jcoffin replied to a thread Local Network Bypass Untangle. in Networking

Bypass rules in Config -> Network -> Bypass will bypass apps (UVM). All conditions are logical AND operator so if condition have Destination = LAN...

1 replies | 260 view(s)

09-24-2021, 07:07 AM

jcoffin replied to a thread Keyboard language option during install on 16.3.2 in Installation

It is currently targeted for the same release as Debian 11 change.

4 replies | 359 view(s)

09-22-2021, 08:09 AM

jcoffin replied to a thread Keyboard language option during install on 16.3.2 in Installation

Looks like it was removed previous to 15.0 build I just tried. It was in the first phase of the installer (hardware setup) so nothing to do with...

4 replies | 359 view(s)

09-17-2021, 09:31 AM

jcoffin replied to a thread V16.3.2 cannot get second site2site OpenVPN working in OpenVPN

Are the 16.3.2 servers new installs or upgrades? There was a change to OpenVPN configuration on 15.0.0 but the change is only applied to new...

2 replies | 395 view(s)

09-17-2021, 09:26 AM

jcoffin replied to a thread OpenVPN on NG Firewall: Connect to WAN from LAN in OpenVPN

OpenVPN is only enabled incoming on the WAN, using one of the LAN networks to connect will not allow the connection. To test use a cellphone with...

4 replies | 471 view(s)

jcoffin
Untangler

Mini Statistics

Basic Information

About jcoffin

Signature

Contact

Statistics

Total Posts

General Information

jcoffin Untangler

Mini Statistics

Basic Information

About jcoffin

Signature

Contact

Statistics

Total Posts

General Information

jcoffin
Untangler