Results 1 to 4 of 4

Thread: Vrrp

  1. #1
    Join Date
    Jun 2015

    Default Vrrp

    hello Community,

    we want to use VRRP for our internal network. Is it possible to configure it like in the attached file?

    Thank you

    Kind regards


  2. #2
    Untangle Ninja
    WebFooL's Avatar
    Join Date
    Jan 2009
    Sweden (Eskilstuna)


    Hi and welcome to the forum!

    If i read your image correctly you want
    UT1 Ext
    UT1 Int
    UT1 Int VRRP

    UT2 Ext
    UT2 Int
    UT2 Int VRRP

    The only error I can spot is that UT1 has Internal and VRRP address set to the same.
    And i would if you can use VRRP on the External interface as well.

    The sample that you have marked-over you can see that the VRRP has and UT1 has .2 UT2 has .3.
    So the IP you want as GW needs to bee the VRRP ip and then both units need there own.
    So minimum 3 addresses are needed.

  3. #3
    Join Date
    Jun 2015


    Okay thank you, external doesn't matter at the moment.

    The Focus was at the internal VRRP. I saw an other article, where it was like in my picture. One untangle und the VRRP-Address was the same. (but it wasnt untangle specific)

    So we need to use an additional IP Adress for VRRP.

    Sorry for my english, it's not my mother tongue.

  4. #4
    Untangle Ninja sky-knight's Avatar
    Join Date
    Apr 2008
    Phoenix, AZ


    Yes, VRRP requires each interface to have it's own IP address as normal, and you create a virtual address that all the cluster members will "share". The only other thing you need to watch out for is you need to ensure that the Untangle that has the master role for one VRRP virtual address, has the master role for ALL virtual addresses. Just in case you decide to add a virtual WAN address in the future.
    Rob Sandling, BS:SWE, MCP
    Phone: 866-794-8879 x201

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

SEO by vBSEO 3.6.0 PL2