VLAN setup problems

[GodAtum]

Hi all,

I have setup a physical interface on eth1:

Capture1.JPG

with a bridged interface on eth2:

Capture2.JPG

with a VLAN 4:

Capture3.JPG

From eth2 I connect to my Netgear GS716T port 2. On that switch I have a PC connected to port 11 which should be on VLAN4.

[GodAtum]

Switch screenshots:

Capture4.JPG

Capture5.JPG

Capture6.JPG

[Jim.Alles]

OK, we don't see the question

[GodAtum]

OK, we don't see the question

Sorry the VLAN does not work. My PC on VLAN4 cannot connect to the internet nor 10.0.4.100.

[sky-knight]

Needs a trunking port aimed at Untangle. The port with the PC on it is correctly set to tagged.

It's not working because the switch isn't putting the correct PVID (VLAN tag on switch egress) on the frames on the way to Untangle. Enabling Trunc should solve that.

[GodAtum]

Needs a trunking port aimed at Untangle. The port with the PC on it is correctly set to tagged.

It's not working because the switch isn't putting the correct PVID (VLAN tag on switch egress) on the frames on the way to Untangle. Enabling Trunc should solve that.

Sorry I'm not sure what you mean? On the switch I've set port 2 (the one doing to Untangle) as T (tagged) for the default VLAN and VLAN4 with the PVID to 4 (see sceenshots above).

I must be missing something

[abailey]

Just from a quick glance it seems your port 2 on the switch should be a Tagged member of VLAN 4 and an untagged member of VLAN 1. You have not defined VLAN1 in Untangle so you can't send it tagged from the switch. To get around this I disable my interfaces on Untangle and run all VLANs. In Untangle you can disable the interface without disabling the VLAN interfaces attached to them.

Though now that I think about it that should still not stop your PC from seeing the internet I would not think.

[GodAtum]

So I tried connected the PC directly to the cable coming out of Untangle eth2. And set the VLAn to 4 on the PC's NIC. It doesn't get an IP even though there is DHCP serving.

Capture7.JPG

[soldier]

Erase (set to default) g2 interface in port PVID configuration (1,1,1,none) and I think you should be good. Tell me if that works.

[GodAtum]

Erase (set to default) g2 interface in port PVID configuration (1,1,1,none) and I think you should be good. Tell me if that works.

Unfortunately not.