Search:

Type: Posts; User: justinbest

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    1,101

    Thanks for the advice! My Guest WiFi access point...

    Thanks for the advice! My Guest WiFi access point is plugged into the DMZ interface, so I've created a Packet Filter rule (under Config -> Networking -> Advanced -> Packet Filter) named "Isolate...
  2. Replies
    6
    Views
    1,101

    Packet filter rules don't have a "destination...

    Packet filter rules don't have a "destination interface" or "destination network" option... I've played around with them and I haven't found a way to successfully prevent traffic from DMZ <--> LAN....
  3. Replies
    6
    Views
    1,101

    Thanks! I understand from your message that this...

    Thanks! I understand from your message that this is not the right method ("you should not use it")

    How should I prevent traffic from routing between LAN and DMZ? I'm using the DMZ segment as the...
  4. Replies
    6
    Views
    1,101

    Where did "Only NAT WAN Traffic" go?

    I'm using DMZ as a Guest WiFi segment, and am trying to prevent DMZ from ever accessing the LAN segment.

    The advice I keep coming up with on the forums says to uncheck "NAT only WAN traffic" in...
  5. Thread: SSD vs HDD?

    by justinbest
    Replies
    80
    Views
    23,601

    SSD vs HDD?

    Hi all,

    Building my first untangle box in a long, long time and I'm curious what the current status of the "SSD vs HDD" debate is for Untangle?

    I'm trying to deploy the same hardware across...
  6. Replies
    2
    Views
    1,089

    Thank you!

    Following suggestions in your post did indeed resolve my issues completely. I am now able to use the untangle box without problems!

    Thanks for taking the time to explain things to me, it is very...
  7. Replies
    2
    Views
    1,089

    Must use as a Router?

    Hi,

    I am new to the Untangle gateway.

    Here is a summary of my network topology. Three sites are tied together using VPN, and three sites are tied together using point-to-point T1. For a more...
  8. Replies
    32
    Views
    6,687

    I'm new, but...

    I'm new to Untangle, so I don't know if this is correct, but if you're in bridge mode, I think you should set your "outside address" on Untangle to be in the 10.10.15.X subnet, and then you should go...
Results 1 to 8 of 8

SEO by vBSEO 3.6.0 PL2