Search:

I am pretty stumped what is wrong with my environment, but I seem to be having some serious performance issues relating to my internet bandwidth. I've tested bandwidth with my laptop connected to my...

Although through the help with people on the forums, and digging through some documents, everything in my environment is working correctly. However, bandwidth seems to be screwed up as speeds are...

Right now my network has hit max nodes (giving out 30 iPhones did me in). We have a 10.0.0.0/24 network where .1 - .99 are reserved and .100 - 254 are in the DHCP range. Now one thing I could do is...

Thanks a lot. This will work until I can move my DHCP server over.

Yes it helps :). The green light seems to do the trick. My only issue now is that although it does seem to be working, I seem to be getting a very minimal bandwidth for internet. I have to check some...

By default, my Untangle box gives out the DNS server of itself if configured, otherwise, it gives out the ISP DNS. I have other internal DNS servers though, but can't seem to find a way to have it...

I contacted support and well.. my WAN Load Balancing app was off.

*facepalm*

Thanks for the help all.

Physical hardware box. Pretty simple config as it goes:

Fiber Equipment -> Untangle Box Wan1
Cable Modem -> Untangle Box Dmz (wan2)

Untangle Box -> Lan1 - > network switch

I am using the following version:
Build: 9.2.1~svn20120328r31539release9.2-1lenny
Kernel: 2.6.26-2-untangle-686

Here is my DMZ connection which is WAN2. I have it configured as WAN:...

I can't seem to connect to my second WAN at all which is very strange. I think this is the obvious cause to my issue. I tried to disconnect WAN2, shut it off, plugged it into my laptop, configured my...

Spoke too soon. I will try to reboot and see how it works. Thanks

Well I was able to configure this but it doesn't seem to work. When I check what my IP is, it still displays the WAN1 interface when it should be WAN2 (i even ran tests). It does list External for...

Both untangle boxes are directly behind the WAN connection - but all is well now. Maybe I just needed to sleep on it. I plugged them in this morning, went through configs on both devices and...

I have two Watchguard firewalls at two different sites that are configured as a tunnel so that each site can see nodes at the other location.

I started configuring it as so:
site1.com -> IPSec...

Anyone know if there is a way to setup network balancing to actually be more of a usage based on IP range? I set the following up
Servers - 10.0.0.1 -> 10.0.0.69
Desktops - 10.0.0.70 -> 10.0.0.254...