WireGuard goes cold when doing network changes

[bndt206]

Hi

I've noticed a couple of times where I cannot push data through the tunnel. The VPN connects flawlessly but no traffic comes through, then I can log on through command center, then switch off/on wireguard and ba-da-bing - it works again. I'm not quite sure why this happens but when even I change something in the Network > Interface settings, wireguard has to be restarted.

Has anyone noticed this behavior?

[jcoffin]

It's a known issue when adding routes and NAT rules. There might be other network changes also affecting WG. We are looking into it.

[manilx]

This happened to me s lot when doing other changes....

[ncksh]

Can confirm i have seen the same, disable / re enable WG seems to fix it.

[jcoffin]

This happened to me s lot when doing other changes....

Please list any changes you run into as it will help in verification of the code fix.